Every conceivable environment has been thrown at the locker by development engineers and customers and the Aussie Locker gets them where they want to go, every time. The Aussie Locker is the result of attention to detail not previously seen in the industry. Special steel alloys for maximum durability and long life, proprietary manufacturing processes, unique heat treatment procedures and 100% quality audits with electronic microscopes result in every Jeep locker providing unmatched reliability and performance.

No air lines to leak, break or compressors to fail, no cables to fray, no electric wires to break, the Aussie Locker gets you where you want to go, with maximum traction performance. You get 100% traction performance rather than 40-60% with a posi or LSD. And with the unique construction and manufacturing process the Aussie Locker delivers this 100% traction year after year after year. No degradation over time like some other products out there. And the Aussie Locker can be installed by the weekend mechanic. If you can install a set of brakes you can install your Aussie Locker without any specials tools or training. The No-Nonsense Two Year Limited Warranty has no restrictions on tire size or horsepower. The Aussie Locker is designed to hold up whatever you throw at them, time after time.

Front Axle Installations
The installation manual provided with your Aussie Locker contains information on proper front axle installations. The Aussie Locker works well in front axles for 4 Wheel Drive vehicles when they are installed in a vehicle with locking hubs or those equipped with front axle disconnect.

Under no circumstances should the Aussie Locker be installed in the front of a full- time 4 wheel drive vehicle.

To prevent damage to the drive line no four wheel drive vehicle should be driven on the highway with the front hubs locked and the 4 wheel drive engaged. The Aussie Locker in the front differential of a 4 wheel drive vehicle (excepting full-time 4WD), properly equipped and installed, provides dramatic off road traction and very good on-highway handling.

Non-ABS diffs only (with large journal side gears). Please verify your diff is a Dana. Chrysler 8.25" diffs were also used in many of the XJ's during these years. If in doubt check your VIN number before ordering.